Connecting VyOS server to a network
This guide describes how to configure a VyOS server in private network.
VyOS VDS's are often used as routers and can handle VPNs of different types and configurations.
Setup
After VPS connection to a LAN in a control panel, connect to the server over ssh and enter VyOS configuration mode:
Note: In normal mode, some utilities are unavailable and command prompt ends up with “$“, while in configuration mode it ends up with “#“.
Display all available interfaces:
address XXX.XXX.XXX.XXX /24
duplex auto
hw-id
smp_affinity auto
speed auto
}
ethernet eth1 {
duplex auto
hw-id
smp_affinity auto
speed auto
} loopback lo {
}
Use set command to set local IP address; if DHCP option is disabled for the network, then take an address from a control panel on your VPS settings tab and set it as a value (see figure below):
For example:
If DHCP option is enabled, execute the following command:
Note: If an error is returned, try including a current user in a superuser group (for example, usermod -a -G root ).
Check modifications:
+ address /
duplex auto
hw-id 00:50:56:01:1b:9f
smp_affinity auto speed auto
}
loopback lo {
}
Modified lines are marked with “+”.
If everything is OK, then commit and save changes:
save
Exit configuration mode:
Check the configured local IP address of VyOS interface:
Interface
---------
eth0
eth1
lo
IP Address
----------
XXX.XXX.XXX.XXX/24
10.0.0.2/24
127.0.0.1/8
::1/128
S/L
---
u/u
u/u
u/u
Description
-----------
Now, you can use the configured machine as a router or other node in a private network.